Subject: Re: [Elecraft] OK to use "Flux Off" on K2 ???
Date:     Sun, 11 Jul 1999 13:37:34 -0700
From:    Eric Swartz WA6HHQ - Elecraft <erics@elecraft.com>
 
If you use a flux remover, please do NOT spray it on the board. (It may damage some of the parts if it seeps inside them.) Instead, use a Q-Tip or other small cloth wipe and saturate it first with the remover and then rub it on the area to clean.

-----------
Fred Bennett N9TA wrote:

 I suppose I should have asked allready....BUT....is it  OK to use "Flux Off" by Chemtronics to remove excess flux from K2 ??